When window glass becomes damaged it needs to be repaired or replaced. If it isn’t, the damage can impact visibility, increase energy loss, and cause drafts in the home. If you’re considering glass replacement, it’s important to explore all of your options. Whether you want to boost your home’s curb appeal, or you’re looking for a more efficient option, read this article to learn more about the process of replacing glass in windows and doors.
The first step in the window replacement process is measuring the frame opening. This can be done using a tape measure or by drawing an approximate outline of the window with a pencil on paper. It is best to make this measurement in several places to ensure accuracy.
Once the rough opening measurements are taken it is time to order new window glass. The most important thing to remember when ordering is to allow for a two-inch gap around all sides of the window for shimming and insulation. This is also the area that will be cut when the window is installed.
A professional installer will remove the existing window from the frame and sash. This can be a difficult task as the window is often secured with clips and retainers that can be difficult to remove. Once the old window is removed it is necessary to clean the frame and sash to remove any debris or dust that could affect the new glass.
The new urethane adhesive is then applied and allowed to rest. The glazier points are then laid in place to secure the new pane of glass. This is the most difficult part of the process and requires a high level of skill. If done incorrectly the new pane of glass will fall from the frame, cause drafts in the home, or even break.
After the glazier points are in place the window is then cleaned. It is very important to use a non-acidic cleaner to avoid damaging the new glass. The installer will then re-secure the clips and any other retainers and fasteners that were removed earlier.
Depending on the location of the glass damage it may be possible to repair the windshield or side windows. However, if the damaged area is in the driver’s field of vision it can decrease safety and should be replaced immediately. Also, if the damage is near the edge of the glass it may no longer be able to hold the seal and will need to be replaced.
In most cases original equipment replacement auto glass is required and must be installed by an authorized dealer to ensure ADAS systems are calibrated properly. This is especially important on vehicles with a camera mounted behind the windshield. While some windshield repair companies can perform this calibration, it is recommended that you contact your dealership for assistance. The dealer will determine if this is covered under warranty. If not, they will provide a quote for the cost of the new glass and installation.
source https://innovativeglass.wordpress.com/2025/04/04/the-process-of-glass-replacement/
No comments:
Post a Comment